Calibrations

1. PID Tune

2. Manual Bed Leveling

3. Automatic Bed Leveling

4. Flow Rate Multiplier

5. Jerk

6. Acceleration

7. Retraction

Steps/mm:

• Measure 120-150mm of filament from the entry to the extruder.

• Heat hotend to desired printing temperature.

• Use the Move functionality of the printer to push 100mm of filament through the hotend.

• Measure the remaining amount. The extra 20-50 mm of filament is intended to let you easily measure the amount if MORE than the specified 100mm gets fed through the printer.

• Go into the Settings for the printer and find the currently set Steps/mm setting.

• Use the following formula to calculate new Steps/mm value:

• Amount of filament printer was SUPPOSED to feed through the printer divided by the Amount of filament ACTUALLY fed through the printer times the current Steps/mm value.

I just did this on my printer and these are my values:

• Amount printer should have fed through the printer: 100mm

• Amount of filament fed through the printer: 105mm

• Current Steps/mm Value: 110.5

• 100/105 = .9523

• .9523*110.5 = 105.23